We assume that you already have a plastic window and it remains only to install it. What is required for this? Installation. In order to install a plastic window with your own hands, you need to prepare a tool and blanks. After preparing the desired tool, it is also advisable to saw the racks (pieces 10), 4×4 cm in size. Each or a beam, to set the frames horizontally, it all depends on the difference on the parapet. The installation is as follows: – It is necessary to remove the double -glazed window from the frames and put it on the pre -arranged surface on the floor. If you need to remove several double -glazed windows from the frame at once, then place them, leaning on the wall, laying them quite strong and soft material. Moving sash are removed as follows: first you need to slightly pull the rod on the upper loop down, after which lower it almost to the end with pliers than we will release the sash from the upper loop. Next, tilting the sash to you, lift the sash up five centimeters, after which it will easily be freed from the loop. Now you can put a standing profile. For its installation, we turn the frame “upside down”, take the standing profile (plastic stick that matches the size of a long frame), put the profile in the groove, remove it by frame (vertical), after which, with small tappings, we attach it to the lower side of the frame. Profile for the frame are necessary for further installation of window sills. We turn the frame into a normal position and begin the next stage of installation. Now there was a turn of mounting mounts on the window frames the standard option: take 15 cm at a turn from all edges of the frame and fix the fixing plate (to the upper part of the frame). The plate must be driven with a hammer into the special internal openings of the frame, then expand the outstanding part from the right angle for further fixing to the walls. The direct installation of plastic windows we mount plastic frames on the parapet, hold on both sides by different “installers” and approximately pretend to be the error vertically using the level. Then we climb onto the ladder and fix one mount. Next, we fix the other frames and tighten one to the other using six -centimeter screws. After connecting the parts into a single whole, we begin to align it in level. The level and plumb line will come in handy in this case.